headlight bulb position

Stanley ball Replies  3 Last Reply : Jul 29, 2018
Would like to know where the high beam bulb goes, inside, or on the outside. 62 Bel Air...

Read More

1957 chevy 10 bolt rearend

Keith Replies  1 Last Reply : Aug 12, 2015
I was wondering what the measurement would be from backing plate to backing plate. Thanks...

Read More

Generator light always on

Roger Baugher Replies  1 Last Reply : Aug 5, 2015
is there an easy test for this or must it go to a repair shop?...

Read More

6-Cyl vs V8

Harry Bellend Replies  1 Last Reply : Feb 23, 2015
How common were 55-57 Chevys with 6-cylinder engines? It would be interesting to know what the take rate was of the new and novel soon-to-be-legendry small-block V8 engine. Was there ever a point in the sale of full-size Chevrolets where the V8 became far more common? I have never driven a 6-cyl equipped classic Chevy, but I would think it would be...

Read More

vin number on 59 impala conv

Willy Replies  3 Last Reply : Jun 21, 2011
my car is missing the vin plate but i got a title with the car. where on the car can i find another number to make sure it matches the title that i have?...

Read More

Dashboard Header for 1994 Camaro

Darleen Walter Replies  3 Last Reply : Jun 21, 2011
Hi! I have a 1994 Camaro (basic model, not a Z28) and the top part of the dashboard (i'm calling it a dashboard header, not really sure what the correct part name is) cracked from the sun. Stupid me, i tried to temporarily fix it and Krazy Glued the crack, but a bit of the glue ran down to my thumb and left a lovely thumbprint on the dash. I w...

Read More

Ignition wiring

top cat Replies  1 Last Reply : Jun 21, 2011
The wiring from my starter to ignition switch, ballast resistor and coil do not match the diagram in my Repair Manual. I suspect this is causing some issues with the ignition system. How crucial is this? I match with violet wire ffrom starter to switch and tan sire to top of ballast resistor. Then I have a wire from bottom of resistor to + side of ...

Read More

1963 Impala Conv Top Rails sagging

James K. Stallings Replies  1 Last Reply : Jun 21, 2011
The GM convertible tops of the early 60's have a square head screw on the first hinge point in the side rails, this is the "lower" the joint making the joint go lower onto the window frame, Mine is already too low, so how would one raise that rail?? I don't see any adjuster to do that particular adjustment...

Read More

57' Continental Kit

PEPE Replies  32 Last Reply : Jun 21, 2011
Is there anywhere I can find a complete "Continental Kit" for a 57' 2 Door Hardtop?...

Read More

engine numbers

Tommy Replies  2 Last Reply : Jun 20, 2011
I have a 1972 Nova SS with a 396. From what I understand, that year only came with a 350. I also heard that if that car was specially ordered that way in that year it may have origially been a 396 or maybe a 402. If anyone has any feed back on this issue, I would certainly appreciate it. Further, where is the engine number for ID located on a 396/4...

Read More